Eremex team is pleased to invite you to visit our presentations at DAC 2013

Specifics and Advantages of Flexible Topological Any Angle Routing Agenda:

There are four ways to increase the density of interconnections and component assembly on printed circuit boards:

• Decrease the size of vias and pads to make some room for wire routing
• Increase the number of routes between vias by decreasing wire widths and clearances
• Replace through vias with blind and buried vias
• Add more layers

All of this, however, brings up the board production costs. But there is another way: flexible topological any-angle routing, as implemented in the TopoR (for TOPOlogical Router) PCB topology design system.

To learn more  visit our booth 1938 at DAC 2013 Show.

3 June – 5 June 2013.  Booth 1938, DAC 2013,  Austin Convention Center. 500 East Cesar Chavez Street, Austin, TX 78701, USA

Presentations start every hour!

DAC Floor Plan

DAC official web-site